Select Load Size; Soil Level; Press Start/Pause/Unlock To Begin Wash Cycle - Maytag W10560151B Use And Care Manual

7.

Select LOAD SIZE

Select the load size setting most suitable for your load. Small will
add a low amount of water for smaller loads and Super will add
the most amount of water for large or bulky loads. Items need to
move freely.
8.
Select WASH TEMP and

SOIL LEVEL

After selecting the Load Size, turn Wash Temp or Soil Level
knobs to select the cycle modifier, if desired. Not all settings
are available with all cycles. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than your
hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature from your
faucet. If your tap cold water is
very cold, warm water may be added
to assist in soil removal and help
dissolve detergent.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
9.
Select Cycle Options
Select the desired cycle options. If you are using fabric softener,
be sure to select one of the One Rinse with Fabric Softener or
Extra Rinse with Fabric softener options.
10.
Press START/Pause/Unlock
to begin wash cycle
Press the START/Pause/Unlock button to start the wash cycle.
When the cycle has finished, the DONE indicator will light.
Promptly remove garments after cycle has completed
to avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
Pause/Unlock again to restart the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
9