ZyXEL Communications Prestige 661H Series User Manual page 404

Table 138
FIELD
Keep Alive
Local ID type
Content
My IP Addr
Peer ID type
Content
Secure
Gateway
Address
Protocol
DNS Server
Chapter 42 VPN/IPSec Setup
Menu 27.1.1 IPSec Setup (continued)
DESCRIPTION
Press [SPACE BAR] to choose either Yes or No. Choose Yes and press [ENTER] to
have the Prestige automatically re-initiate the SA after the SA lifetime times out, even
if there is no traffic. The remote IPSec router must also have keep alive enabled in
order for this feature to work.
Press [SPACE BAR] to choose IP, DNS, or E-mail and press [ENTER].
Select IP to identify this Prestige by its IP address.
Select DNS to identify this Prestige by a domain name.
Select E-mail to identify this Prestige by an e-mail address.
When you select IP in the Local ID Type field, type the IP address of your computer
or leave the field blank to have the Prestige automatically use its own IP address.
When you select DNS in the Local ID Type field, type a domain name (up to 31
characters) by which to identify this Prestige.
When you select E-mail in the Local ID Type field, type an e-mail address (up to 31
characters) by which to identify this Prestige.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address.
Enter the IP address of your Prestige. The Prestige uses its current WAN IP address
(static or dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0.
The VPN tunnel has to be rebuilt if this IP address changes.
Press [SPACE BAR] to choose IP, DNS, or E-mail and press [ENTER].
Select IP to identify the remote IPSec router by its IP address.
Select DNS to identify the remote IPSec router by a domain name.
Select E-mail to identify the remote IPSec router by an e-mail address.
When you select IP in the Peer ID Type field, type the IP address of the computer
with which you will make the VPN connection or leave the field blank to have the
Prestige automatically use the address in the Secure Gateway Address field.
When you select DNS in the Peer ID Type field, type a domain name (up to 31
characters) by which to identify the remote IPSec router.
When you select E-mail in the Peer ID Type field, type an e-mail address (up to 31
characters) by which to identify the remote IPSec router.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address. The domain name also does not have to match the remote router's IP
address or what you configure in the Secure Gateway Address field below.
Type the IP address or the domain name (up to 31 characters) of the IPSec router
with which you're making the VPN connection.
Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address (the
Key Management field must be set to IKE, see later).
Enter 1 for ICMP, 6 for TCP, 17 for UDP, etc. 0 is the default and signifies any
protocol.
If there is a private DNS server that services the VPN, type its IP address here. The
Prestige assigns this additional DNS server to the Prestige's DHCP clients that have
IP addresses in this IPSec rule's range of local addresses.
A DNS server allows clients on the VPN to find other computers and servers on the
VPN by their (private) domain names.
Prestige 661H/HW Series User's Guide
404