Table of Contents
Advertisement
5.3.3
S.M.A.R.T. commands
S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors predetermined drive
attributes that are susceptible to degradation over time. If self-monitoring determines that a failure is likely, S.M.A.R.T. makes a status
report available to the host. Not all failures are predictable. S.M.A.R.T. predictability is limited to the attributes the drive can monitor. For
more information on S.M.A.R.T. commands and implementation, see the Draft ATA-8 Standard.
SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4
returns. The diagnostic software ships with all new drives and is also available at:
http://seatools.seagate.com.
This drive is shipped with S.M.A.R.T. features disabled. You must have a recent BIOS or software package that supports S.M.A.R.T. to
enable this feature. The table below shows the S.M.A.R.T. command codes that the drive uses.
Table 9 S.M.A.R.T. commands
C
ODE IN FEATURES
REGISTER
D0
H
D1
H
D2
H
D3
H
D4
H
D5
H
D6
H
D7
H
D8
H
D9
H
DA
H
If an appropriate code is not written to the Features Register, the
N
OTE
command is aborted and 0x 04 (abort) is written to the Error register.
M
T
P
OMENTUS
HIN
RODUCT
S.M.A.R.T.
COMMAND
S.M.A.R.T. Read Data
Vendor-specific
S.M.A.R.T. Enable/Disable Attribute Autosave
S.M.A.R.T. Save Attribute Values
S.M.A.R.T. Execute Off-line Immediate (runs DST)
S.M.A.R.T. Read Log Sector
S.M.A.R.T. Write Log Sector
Vendor-specific
S.M.A.R.T. Enable Operations
S.M.A.R.T. Disable Operations
S.M.A.R.T. Return Status
M
, G
-2 R
. G
ANUAL
EN
EV
) that eliminates unnecessary drive
H
30
Advertisement
Table of Contents
