Parts And Functions; Display Board - Haier HSM18HEKC03/R2 Service Manual

HSM18HEKC/HRAC03/R2(DB) HUM18HC03/R2(DB) -SM

Parts and Functions

Inlet
Inlet grille
Outlet
Vertical blade
(adjust left and
r ight air fl
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
Please be subject to the actual produce purchased the
above picture is just from your reference

Display board

1 2
1
Signal receiver hole
2
ON/OFF display
3
Ambient temp.display
When receiving the remote
control signal, display the set
temperature and in the rest
time the room temperature is
displayed and this room
temperature is only for reference.
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
(inside)
Emergency
Switch
ow)
Display board
4
5
3
4 TIMER ON\OFF display
TIMER ON-OFF display
SLEEP display
Note to the power failure resume:
press the sleep button ten times in five seconds
and enter function after hearing four sounds.And
press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.
5
COOL\HEAT\Dry\ AUTO display
4
1
2
3
4
5
10
11
12
13
14
15
16
17
18
1. Mode display
Operation mode
SMART AUTO COOL DRY
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
LO MED HI
5. LOCK display
6. TIMER OFF display
TIMER ON display
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-sta rted type fluorescent lamp or change- over
type fluorescent lamp or
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
ries have been used up. Please change batteries.
batte
If the remote controller can't run normally during operation, please
remove the batteries and
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
41
7.TEMP display
6
8.POWER/SOFT display
9. HEALTH display
7
10. QUIET button
11. HEAT button
8
12. COOL button
13. AUTO button
9
14. FAN button
19
15. TIMER button
16. HEALTH button
20
17. LOCK button
21
Used to lock buttons and LCD
display
.
22
18. LIGHT button
Control the lightening and
23
extinguishing of the indoor
LED display board.
24
19. POWER ON/OFF button
25
20. DRY button
21. TEMP button
26
22. SWING button
23. HOUR button
24. EXTRA FUNCTION button
HEAT FAN
25.CANCEL/CONFIRM button
Used to confirm timer and
clock settings.
26. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this
button to reset the remote
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
wireless telephone is installed in the
reload several minutes later.