Haier AB182ACERA Service Manual page 12

Installation Tools
Installation tools
The installation tools listed in the following sheet
can be used as required.
1. Screw driver
2. Hacksaw
3. Drill with a diameter of 60mm
4. Inner hexagon spanner,shifting
spanner
5. Spanner (14, 17, 19,24,27mm)
6. Pipe cutter
7. Pipe expander
8. Knife
9. Pincers
10. Leakage detector or soapy water
11. Band tape
12. Scraper
13. Refrigerant oil
Installation Procedures
1.Selection of Installation Place
(1) Place above the ceiling where it is enough space to arrange the unit.
(2) Place where the drainage pipe can be arranged well.
(3) Place where inlet and outlet air of indoor and outdoor unit will not be blocked.
(4) Do not expose the unit to the place with heavy oil or moisture (e.g.kitchen and workshop).
(5) Do not set the unit in the place where destructive gas (such as sulfuric acid gas) or pungent
gas (thinner and gasoline) concentrates and retains.
(6) Place strong enough to support the unit .
(7) No expensive articles such as television and piano below indoor unit.
(8) Enough space for maintenance.
(9) Place more than 1m away from television and radio to avoid disturbing television and radio.
(10) Easy for maintenance.
12
Commercial Air Conditioner
Air outlet
Air outlet Air inlet
1.5m
2.5m Over
The following parts mentioned in this manual
are the installation accessories we prepared.
Symbol Parts Name
A
Adhesive tape
Pipe clamp
B
C Connecting hose
Drainage hose
D
Non-hydroscopic
E
heat insulating material
Gypsum powder
F
1.5m
Model: AB182ACERA
AC182ACERA