Preparation - Honda WT20X Owner's Manual

3. PREPARATION
1. Connect the suction hose.
Use commercially available hose, hose connector, and hose bands. The
suction hose must be .of reinforced, noncollapsible construction. Suction
hose length should not be longer than necessary, as pump performance is
best when the pump is not far above the water level. Self-priming time is
also proportional to hose length.
The strainer that is provided with the pump should be attached to the end
of the suction hose with a band, as shown.
CAUTION: Always install the strainer on the end of the suction hose
before pumping. The strainer will exclude debris that can cause clogging or
impeller damage.
NOTE: Tighten the hose connector and bands to prevent air leakage and
loss of suction. A looselv connected suction hose will reduce pump perfor-
mance and self-priming gbility.
SUCTION
STRAINER
HOSE
CONNECTOR
J
HOSE 'BAND
2. Connect the discharge hose.
4
Use a commercially available hose, hose connector, and hose band. A
short, large-diameter hose is most efficient. Long or small-diameter hose
increases fluid friction and reduces pump output.
NOTE: Tighten the hose band securely to prevent the hose from discon-
necting under high pressure.
HOSE CONNECTOR