Stylus C40UX/C40SX/C20UX/C20SX
4.2.2 ASF unit removal
1.
Remove the upper housing. (Refer to Section 4.2.1)
2.
Take out the three screws.
CBP 3 8
CBP 3 6
3
1
Figure 4-6. Removing the ASF unit
3.
Pull the ASF unit toward the rear and remove it.
When installing the ASF unit, install the spring in the guide, then
install it while supporting it by hand.
Figure 4-7. reassembling the ASF unit
When reassembling the ASF unit tighten screws form lower
numbers in Figure4-6.
Tightening Torque for screw
- C.B.S 3x6
- C.B.S (P2) 3x6
- C.B.P 3x8
Disassembly and Assembly
CBS (P2) 3 6
2
: 9+/-1 kgf.cm
: 9+/-1 kgf.cm
: 6+/-1 kgf.cm
The Top Margin adjustment is required when the ASF unit is
replaced.
Disassembly
Revision B
63