Stylus C40UX/C40SX/C20UX/C20SX
8.
Disconnect the FFC from the connector.
Figure 4-37. Disconnecting the FFC
If the Carriage unit is disassembled or replaced with a new one,
make sure that the Carriage timing belt is set in the assembling
groove correctly as following figure.
Disassembly and Assembly
FFC
Timing belt
Disassembly
When the Printhead is replaced with a new one, following
adjustments must be performed in the order below: Refer to Table
5-1
1.
Initial ink charge
2.
Head ID input
3.
Bi-D adjustment
When the Printhead is removed and reinstalled, only the following
adjustment is required. Refer to Table 5-1
1.
Head cleaning
2.
Bi-D adjustment
Revision B
75