Using The Battery And Ac Adapter/Charger - Intermec PB2 User Manual

Using the Battery and AC Adapter/Charger

14
PB2 LED State Descriptions (continued)
LED State
Data and Status Off
Steady Green
Flashing Red
Steady Red
Use only Intermec battery model 318-040-001. Use of another
battery may present a risk of fire or explosion.
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not disassemble, heat above 80°C
(176°F), or incinerate.
Note: The battery must be cycled several times to achieve maximum
capacity. To cycle a battery, fully charge it and then allow a full
discharge through normal use. To ensure a full charge, make sure the
printer is off while the battery is charging.
To install the battery
1 Slide the battery door latch toward the belt loop knob to unlock
the battery door, and open the battery door to an angle of about
90 degrees. Do not force the door all the way open.
2 Orient the battery so the arrow points toward the battery contacts
in the battery compartment.
Description
Card was read successfully, or card
cannot be read (for optional magnetic
stripe reader).
Card reader is ready to accept data (for
optional magnetic stripe reader).
Printhead is too hot. Printing pauses
until printhead reaches normal
operating temperature.
One of three conditions:
•
Printer is out of paper.
•
The paper door is open.
•
Card reader error (for optional
magnetic stripe reader).
PB2 Mobile Printer User's Guide