Intermec PW50 User Manual page 46

Chapter A — Specifications
36
When ordering media for the PW50 printer, keep these points in
mind:
• You can use higher caliper media in the printer, but print quality
will be reduced.
• Receipt roll stock media has an end of roll indicator. The end of
roll indicator is a red marking (on last 3 feet of roll) on the
thermally sensitive side of the paper.
External Fanfold Media Specifications
Specification Value
Stack height 70 mm (2.75 in)
Page length 152 mm (6 in) to 305 mm (12 in)
Note: A 6-inch page length is supplied in 12-inch long stacks (two 6-
inch stacks of equal height with the bottom page linked).
Specialty media is required for unique customer environments,
including printer operating temperature extremes. Intermec
recommends that you test the media in your application.
Supported Media
The PW50 printer supports direct thermal receipt media. Receipt
media is supported in both a top coated and an uncoated paper in
continuous roll stock only.
The default media sensitivity number is 401.
Use the following table as a guide when setting sensitivity numbers
for North American receipt media.
Recommended Media Sensitivity, Constant, Factor, and Print Speed
Sensitivity Constant Factor Description
401 45
102 32
101 30
40 Duratherm TC
40 Duratherm NTC - 2
40 Duratherm NTC
PW50 Workboard Printer User's Guide
Max Print Speed
4 ips
4 ips
2 ips