Intermec PW50 User Manual page 38

Chapter 3 — Troubleshooting and Maintaining the PW50
28
Printer Problems and Possible Solutions (continued)
Problem
You press the Standby
button, but the printer
does not enter Standby
mode and the blue
light (Intermec Ready-
to-Work indicator)
starts blinking.
You press and hold the
Standby button for
more than 2 seconds to
enable Bluetooth
communications, but
Bluetooth is not
enabled.
Printer keeps printing
or feeding when it
should stop.
The printout is not in
the desired position.
The printer is not
printing with a
Bluetooth connection.
When printing, the
printer is skipping .
Printout is faded or
weak.
Possible Solution
The printhead may be too hot. Wait until the
printhead cools down and try again.
The printhead may be too hot. Wait until the
printhead cools down and try again.
Check media settings.
Check for errors in the software application.
•
Re-establish a Bluetooth connection with the
mobile computer or scanner. For help, see
"Setting Up Bluetooth Communications" on
page 14, or see your mobile computer user's
manual.
•
Make sure the mobile computer can print to a
known good printer.
•
Print a Bluetooth testprint page to make sure
that the mobile printer discovered your printer.
For help, see "Printing a Testprint" on
page 11.
•
Make sure the printer is in Ready mode.
Perform a testfeed by pressing the Feed button
until the PW50 beeps.
•
Modify the Set Media Sensitivity command
or the Set Dark Adjust command. For help,
see the ESC/P Programmer's Reference
•
Check to see if the printhead needs cleaning. For
help, see "Cleaning the PW50" on page
PW50 Workboard Printer User's Guide
Manual.
30.