Putting the Handset into Operation
Putting the Handset into Operation
Removing the protective cover
Inserting the batteries
The handset is supplied with two approved batteries. The batteries are
supplied uncharged. They are charged in the handset.
1. If attached: remove the attachment clip
Insert a screwdriver between the attachment clip and the battery cover (1)
and force the attachment clip outward (2) until it dislodges.
Also dislodge and remove the clip on the opposite side.
14
Remove the protective cover from the display before
putting the handset into service.
Note:
•
Please observe the safety notes
•
Only use approved batteries
•
Always replace both batteries at the same time and only use
two batteries of the same type/ from the same manufacturer!
•
Open the battery compartment in a dust-free environment only.
•
Your telephone directory entries and all settings remain stored
even if you remove the batteries. The date and time settings
will be reset.
•
Only remove the batteries if they are defective. The battery's
life diminishes each time it is removed.
1
2
Page 2!
Page 17!