Table of Contents
Advertisement
•
The input signal type effects the options available for the Picture Mode. See
picture mode" on page 35
•
For best display picture results, you should select and use an input signal which outputs at
this resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio" on page 34
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector's
HDMI input and the projected picture displays wrong colors, please change the color space
to YUV.
1.
Press MENU/EXIT and then press
2.
Press
suitable color space.
This function is only available when the HDMI input port is in use.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
•
Using the remote control
1.
Press Digital Zoom +/- to display the Zoom
bar.
2.
Press Digital Zoom + to magnify the center
of the picture. Press the key repeatedly until
the picture size is suitable for your need.
3.
Use the directional arrows ( ,
on the projector or remote control to
navigate the picture.
4.
To restore the picture to its original size,
press AUTO. You can also press Digital
Zoom -. When the key is pressed again, the
picture is further reduced until it is restored to the original size.
•
Using the OSD menu
1.
Press MENU/EXIT and then press
2.
Press
displays.
3.
Repeat steps 2-4 in the section of
using the projector control panel, continue to the following steps.
4.
Press
5.
To navigate the picture, press MODE/ENTER to switch to the paning mode and
press the directional arrows ( ,
6.
Use the directional arrows ( ,
navigate the picture.
7.
To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/
out functionality, and press AUTO to restore the picture to its original size. You can
also press
for details.
to highlight Color Space Conversion and press
to highlight Digital Zoom and press MODE/ENTER. The Zoom bar
on the projector repeatedly to magnify the picture to a desired size.
repeatedly until it is restored to the original size.
for details.
/
until the SOURCE menu is highlighted.
,
,
)
/
until the DISPLAY menu is highlighted.
"Using the remote control"
,
,
) to navigate the picture.
,
,
) on the projector or remote control to
"Selecting a
/
to select a
above. Or if you are
Operation 33
Advertisement
Table of Contents
