About Memory - LifeSource UB-521 Instruction Manual

The UB-521 automatically stores up to (90) blood pressure and pulse
measurements in its memory. Measurements stored in memory are
assigned an index number in the order of the newest to the oldest. The
oldest reading displays as "n01".
To retrieve readings, follow these simple steps:
When the display screen is blank, press and hold the
1.
START button. While holding down the START button,
you will see the average reading displayed first. You
will then see the memory index number (e.g. n04) of
the most recent reading followed by the measurement.
Release the START button when you see the memory
index number.
The display will shut off automatically a few seconds
2.
after all of the readings are displayed. To turn off the
monitor at any time, press the START button.
The display will shut off automatically a few seconds
3.
after the readings are displayed.
If there are no measurements stored in memory, two 0s
displayed vertically followed by a blinking "A00"
To clear the measurement history from memory,
remove the battery from the unit and then place the
battery back into the battery holder.
NOTE: Memory will be lost if batteries become low or are removed.

ABOUT MEMORY

E-9