Using The Projector As A Storage Device - NEC L102W User Manual

Using the Projector as a Storage
Device
Important:
• Use the projector's storage area as a temporary storage.
Back up your data on your computer's hard disk drive before using the projector
as a storage device. We will not be liable for any data loss or damage that could
result from using the projector.
If your data is not to be used for a long period time, delete them from the projec-
tor's storage area.
• We will not be liable for any data loss or damage that could result from the
projector's failure or any cause, and we will not be liable for your loss of busi-
ness arising from the data loss or damage.
Our service includes hardware only (not including data recovery).
You can use part of the memory inside the pro-
jector as your storage device.
This memory area can be used for saving and
loading your photos, audio, video, and Office
Reader files.
1.
Turn on the projector.
2.
Press the USB-B button to display the Multimedia and select USB-B
(Connect PC) source.
3.
Use a commercially available USB cable to connect the USB-B port
of the projector and the USB port (A type) of your computer.
4. Press the button to select "Storage Mode" and then press "EN-
TER".
When you see a message as left, the drive has been added to your
computer. This allows you to read and write files to the drive of the
projector.
5. Double clicks the drive of the projector on the Windows "Com-
puter" or "My Computer" on your computer.
You can access two drives of the projector to read or write files.
Note:
• PtG2-setup.exe"is stored on one drive. You cannot store files to this drive. This
drive is read-only. Use the other drive as a storage drive.
• For more information on "PtG2-setup.exe", refer to "Application Guide" on
the supplied CD-ROM.
User Controls
41 ... English