Install Properly; Level Refrigerator; Remove Sales Labels; Clean It - Whirlpool EL11PC Use & Care Manual

Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dlshwashlng detergent solution (1
teaspoon detergent In 1 quart warm water] before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator before plugging It In or using
it See cleaning instructlons on page 7
1 Allow 3 inches (7 5 cm) between overhead cab-
inets and the refrlgeratcx top.
2 Alldw at least an Inch (2.5cm) between the refrlg-
erator condenser and the wall
3. Allow 12 Inch (1 25 cm) on each side of the rem
frigerator for ease of installation
4. If the refrigerator IS to be against a wall, you might
want to leave enough space so the door can be
ooened wider
Level refrigerator.. .
Lower
Plug it in...
I-p10ng
gtoundlng
type
t
gmundmg plug
Pelrlgeralor
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply IS rem
qulred It
IS
recommended that a separate clrcult
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require-
ments and grounding tnstructlon sheet in your liter-
ature package
1 Keep the 4 bolts that held refrigerator in shipping
crate.,They are the levelling legs
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator
3 Adjust each leg until the refrigerator won't rock
Slide refrigerator into place
4. Adjust front legs to level the refrigerator
~ To raise corners, turn legs In direction shown
- To lower corners, turn legs tn dlrection shown
5 Check with level
it
on...
l
Move run switch to RUN
NOTE: The refrigerator motor will not operate un-
ttl the run switch is on RUN.
A