Whirlpool Cabrio WTW6200S User Manual page 66

DISPLAY
(Saved Code)
Open/Close Door Lid
Lid flashes when the following conditions occur:
User presses START with lid open.
•
User presses START after 2 consecutive machine cycles without opening lid.
•
(F81)
The machine/motor control cannot detect the lid switch opening and closing properly.
•
See TEST #8.
Pump Out (lid opened)
Po flashes when drain pump begins pumping out water from tub upon activation by the door lid having been left open for
more than 10 minutes.
(none)
Close door lid to stop drain pump.
•
Hot, Cold Reversed
HC flashes when the hot and cold inlet hoses are reversed.
(none)
Make sure inlet hoses are connected correctly.
•
Door Lock Failure
dL flashes if the following conditions occur:
Door lid is not closed completely due to interference.
•
Wash media buildup is preventing the lock bolt from extending.
•
(F80, 82,
Machine/motor control detects open door lid switch when attempting to lock.
84, 85)
•
Machine/motor control cannot determine if door lid is in a locked state.
•
See TEST #8.
Door Unlock Failure
dU flashes if the following conditions occur:
Excessive force on door lid is preventing lock bolt from retracting.
•
Wash media buildup is preventing lock bolt from retracting.
(F83)
•
Machine/motor control cannot determine if door lid is in an unlocked state.
•
See TEST #8.
Primary Control Failure
F then 1 flashes when there is a primary control failure. Replace the machine control assembly.
See Accessing & Removing the Electronic Assemblies.
(F60-68)
Keypad/User Interface Failure
F then 2 flashes when in:
Diagnostics Test mode if a stuck key is detected.
•
Standby mode if there is a user interface mismatch.
•
(F2)
See TEST #4.
If drain pump turns on when there is no water in tub,
EXPLANATION AND RECOMMENDED PROCEDURE
6-2