Sony DCR-SD1000E Operating Manual page 86

pack while the recording media icon at the top
right corner of the screen flashes, or before
the access lamp is turned off after recording.
This may damage your image data and
displayed.
is indicated on an image on the
VISUAL INDEX screen.
The image data base file may be damaged.

Check the data base file by touching
(MENU)  [Show others] 
[REPAIR IMG.DB F.] (under
MEDIA] category)  the recording medium.
If it still appears, delete the image with
(p. 40).
No sound or only a quiet sound is heard
during playback.
Turn up the volume (p. 34).

When you record sound with [MICREF

LEVEL] (p. 74) set to [LOW], the recorded
sound may be difficult to hear.
Sounds cannot be recorded while shooting

with [SMTH SLW REC].
Playing back images stored on
memory card on other devices
Images cannot be played back or the
memory card is not recognized.
The playback device does not support playing

back memory cards (p. 5).
Editing movies/photos on your
camcorder
Unable to edit.
Unable to edit because of the condition of the

image.
Movies cannot be added in the Playlist.
There is no free space in the recording media.

GB
86

is

A movie cannot be divided.


A photo cannot be captured from a
movie.
[MANAGE

Playback on the TV
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.


The aspect ratio of the playback is not
correct when connecting your camcorder
to the TV.

Dubbing/Connecting to other
devices
Images are not dubbed correctly.

You can add no more than 99 movies to a
Playlist. Erase unnecessary movies from the
Playlist (p. 47).
You cannot add photos in the Playlist.
A movie that is too short cannot be divided.
A protected movie cannot be divided.
The recording media where you want to save
photos is full.
The LCD screen of your camcorder can
display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using
the outer frame of [GUIDEFRAME] (p. 72)
as a guide.
Set [TV TYPE] according to your TV (p. 38).
The A/V connecting cable is not connected
properly. Make sure to connect the cable to the
input jack of another device (p. 61).