Ready To Use; Correction Level Settings - Sunbeam Mini Bark Control Collar Instruction Manual

Note: The BATTERY INSTALLATION and COLLAR FITTINg steps must be completed
before you are ready to use. Complete the steps below while the collar is NOT on your dog.
STEP 1: Holding the main body of the Sunbeam® Mini Bark Control Collar in both hands
PRESS and HOLD the Main Control Button for 4
seconds.
Note: The LED light will flash for 10 seconds
indicating which level is in use.
The default correction level is LOW;
this setting will flash gREEN once
for 10 seconds and then turn off.
See Chart Below.

correction level settings

Level
1 - Low
2 - Medium
3 - High
Flashing red: low battery
The Sunbeam® Mini Bark Control Collar has been designed to maximize battery life and
has a SLEEP MODE that it enters if no user input or barking is detected.
STEP 2: Set correction level by pressing and holding (approximately 2 seconds) the Main Control
Button until a gREEN LED illuminates at the desired setting.
When a gREEN LED is illuminated press the Main Control Button to toggle to the next
correction level. Once a correction level is chosen the gREEN LED will turn off and the
system has entered SLEEP MODE.
Note: It is recommended to start on the LOW setting and monitor your dog's behavior
before determining if a higher correction level is needed.
STEP 3: Attach collar to your dog as you did in the COLLAR FITTINg stage.

reAdy to use

Green LED Light
1 flash (repeated for 10 seconds)
2 flashes (repeated for 10 seconds)
3 flashes (repeated for 10 seconds)
7