Collar Fitting - Sunbeam Mini Bark Control Collar Instruction Manual

• To test the unit turn on by pressing and holding the main control button for 4 seconds.
The LED light will flash for 10 seconds, indicating which correction level is in use.
• To turn off the unit, press and hold the main control button for 4 seconds. The LED light
will illuminate green for 2 seconds, indicating the unit is off.
• When replacing batteries after usage you must completely discharge the collar by
holding a plastic handle screwdriver across both stainless steel probes for 5 seconds.
Make sure the metal portion of the screwdriver is touching both stainless steel probes
and the unit is in the OFF position.
Proper fit of the Sunbeam® Mini Bark Control Collar is essential to establish a good
training foundation and optimal performance.
Note: Batteries should be installed properly and the
collar should be in the OFF position before proceeding
with fitting the collar to your dog.
STEP 1: Ensure dog is in a relaxed position.
STEP 2: With the collar clasp open loosen the adjustment
buckle such that it can reach completely around your dog's
neck. (fig. 4)
Place sensor probe directly over the dog's voicebox. When
buckled, the collar should rest directly behind the dog's ears
(the highest part of the neck). (fig. 5)
Note: Make sure both stainless steel probes go through
the coat completely and make contact with the skin.
Use the longer stainless steel probes if the coat does not allow
the shorter probes to reach the skin.
Before changing the stainless steel probes you must completely discharge the collar by
holding a plastic handle screwdriver across both stainless steel probes for 5 seconds.
Make sure the metal portion of the screwdriver is touching both stainless steel probes
and the unit is in the OFF position.

collAr FittinG

5
figure 4
figure 5