Setting Up The Boundary Flags; Receiver Collar; Battery Installation - Sunbeam in-ground fencing system Instruction Manual

settInG UP tHe boUnDaRy flaGs

• Y ou must set up the Boundary Flags as a visual aid for your dog. The
Boundary Flags will remind your dog where the Boundary Zone is located.
• U sing the Receiver Collar and Test Light as a guide, begin placing your
Boundary Flags at the point where you hear the Warning Tone . Space the
Boundary Flags about one to two yards apart in small yards and about ten to
fifteen feet apart in large yards.
• I f there are areas of the Boundary Zone where you cannot plant the flags
into the ground fill a small can with sand, place the filled can on the edge of
the Boundary Zone and place the flag in the sand. Repeat this process until
you have marked the entire Boundary Zone with Boundary Flags.
ReceIveR collaR oPeRatInG InstRUctIons

batteRy InstallatIon

IMPORTANT: This step is to be completed when the collar is NOT on your dog.
• R emove two screws securing the battery compartment using a cross head
or Phillips head screwdriver. (fig. 24)
• L ift battery compartment from main body of Receiver Collar. (fig. 25)
• I nsert two CR2032 Lithium coin batteries into battery compartment.
Batteries should be placed with the positive side facing down.
IMPORTANT: Follow orientation as described on graphics illustrated
on battery compartment. (fig. 26)
• R eplace battery compartment with two CR2032 Lithium coin batteries back
into main body. Note: The battery compartment can only be assembled in
one orientation, do not force closed. See markings on the battery door.
• T ighten the two screws using the cross-head screwdriver, do not over tighten.
• T o test the unit turn on by pressing and holding the control button for
4 seconds. You will hear one long beep followed by a sequence of short
beeps and flashing green LED indicating which correction level is in use.
The Receiver Collar will recall the last setting or the default setting
(level 1 or low).
• T o turn off the unit, press and hold the control button for 4 seconds. You will
hear short beeps indicating the current correction level followed by a long
beep indicating the unit is off.
• B efore replacing batteries you must completely discharge the Receiver
Collar . Be sure the unit is in the OFF position and place the metal portion
of a plastic handle screwdriver across both stainless steel probes for
5 seconds. Dispose of batteries per local, state and national laws
and regulations .
17
figure 24
figure 25
figure 26