Installing The Boundary Wire; Using An Existing Fence; To Cross Driveways & Pathways - Sunbeam in-ground fencing system Instruction Manual

InstallInG tHe boUnDaRy WIRe

The Boundary Wire is buried to protect it from being damaged. If the Boundary Wire is damaged you risk having
gaps where there could be poor signal strength in your In Ground Fence.
• U sing a shovel, dig a narrow trench along your planned Boundary Zone where you will lay your Boundary
Wire. The trench should be about 3 to 6 inches deep. Use a blunt tool such as a wooden paint stick to push the
boundary wire into the trench. Be careful not to damage the boundary wire insulation.
• P lace the Boundary Wire into the trench and bury the wire. It is
recommended that you lay your Boundary Wire in one yard sections .
Make sure you allow some slack when laying the Boundary Wire
to allow for expansion and contraction with temperature variations.
• C over the area where you buried the wire and tap on the surface
lightly to secure .
• I f you are creating a double loop layout, make sure the parallel
Boundary Wire is separated by 4 to 5 feet.

UsInG an exIstInG fence

You can use an existing fence as part of your single or double loop layout.
If you are using a double loop layout you should run the two parallel Boundary Wires at least 4-5 feet apart to avoid
interference and canceling the signal.
At a gate opening, bury the wire in the
ground under the gate . Ensure you are
maintaining the 4 to 5 feet separation
in the Boundary Wire if you are using a
double loop. Remember that your dog
cannot pass through the gate as the
signal is still active. (fig. 16)
There are different methods used
to secure the Boundary Wire to the
fence. The method is based on the
type of fence you have. (fig. 17)
Wooden Fence: Using a staple gun, staple the Boundary Wire to the fence. Avoid puncturing the Boundary Wire
as this will damage the system .
Chain Link Fence: Weave the Boundary Wire through the links and use plastic zip ties to secure the wire.
Vinyl Fence: Contact your fence manufacturer or retailer for best method to secure the Boundary Wire to the fence.
to cRoss DRIveWays & PatHWays
If your Boundary Zone requires you to cross a concrete driveway or sidewalk consult a professional.
figure 16
14
STAPLE WIRE TO FENCE
STAPLE WIRE TO FENCE
WEAVE WIRE INTO FENCE
figure 17