Advertisement
6. BULB REPLACEMENT
For bulb replacement you will need a small Phillips-head screwdriver. To replace the
bulb (see Figure 3A and Figure 3B):
1. Disconnect the spotlight from the charging/power source.
2. Remove the battery cover (see battery replacement section 8.1 and Ffigure 4 for
directions).
3. Disconnect one wire from a battery terminal.
4. Remove the rubber bezel by pulling it away from the spotlight lens.
5. Remove the two Phillips-head screws that hold the retaining ring to the spotlight
body.
6. Pull off the retaining ring and set it aside.
7. Carefully remove the glass lens, rubber "O" ring and reflector assembly.
8. Loosen (no need to fully remove) the Phillips-head screw in the neck of the reflector
assembly - this will release the bulb unit.
9. Disconnect the bulb's center conductor wire from it's connecting wire.
10. Gently pull out the bulb unit and replace with a new H3 12 volt halogen bulb from
Vector (or minimum H3 12V 55W), available from an electrical supply house or
from Vector's technical support department, call (954) 584-4446.
11. Reverse the above procedure to re-assemble the spotlight.
FIGURE 3A
RETAINING
RING
RUBBER BEZEL
GLASS
LENS
RUBBER O
RING
PHILLIPS
SCREWS
™
URING,
Ltd.
MANUFACT
REFLECTOR
BATTERY
COVER
BATTERY
4
Advertisement
