Table of Contents
Advertisement
CLI Command
channel-group port-channel-number mode {on | auto} Configures a port to a Port channel.
show interface port_channel
The following is an example of the CLI commands:
Console# channel-group port-channel-number mode on auto 1
Port-Channel 1:Port Type 1000 Ethernet
Actor
System Priority:1
MAC Address: 000285:0E1C00
Admin Key: 29
Oper Key: 29
Partner
System Priority:0
MAC Address: 000000:000000
Oper Key: 14
Multicast Forwarding Support
Multicast forwarding allows a single packet to be forwarded to multiple destinations. L2 Multicast service is based on a L2 switch receiving a single packet
addressed to a specific multicast addresses. Multicast forwarding creates copies of the packet, and transmits the packets to the relevant ports.
PowerConnect 3324/3348 supports both:
Forwarding L2 Multicast Packets—Enabled by default.
l
Filtering L2 Multicast Packets—Enables forwarding L2 packets to ports VLAN. If multicast filtering is disabled, multicast packets are flooded to all
l
relevant VLAN ports.
To open the Multicast Support page:
Click Switch > Multicast Support in the Tree View. The Multicast Support page opens.
l
Description
Displays the interfaces attached to a LAG.
Advertisement
Table of Contents
