Display Bezel - Dell Latitude X1 Service Manual

1 display cable connector
pull-tab
2 display cable ground
screw (if present)
3 M2 x 5-mm screws (2)
4 antenna cable connectors
(2)
Display Bezel
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the display assembly.
3. Use a plastic scribe to pry the four round display-bumpers out of the screw holes located on the front of the display bezel. Do not remove the other
bumpers.
4. Remove the four M2 x 4-mm screws located under the bumpers on the front of the bezel.
NOTICE: Carefully separate the display bezel from the top cover to avoid damage to the bezel.
5. Use a plastic scribe to separate the bezel from the top cover by lifting the outside edge of the bezel away from the top cover.
NOTE: You may need to use a plastic scribe to begin the separation.
Pull the bezel from the top edge from the front of the panel toward the sides to open the snaps.
NOTICE: To avoid damaging the bezel, start pulling the bezel up near the bottom of the display (near the DELL™ logo) and work around the display
and toward the top of the display.
Computer."