Optical Drive - Dell Inspiron 9300 Owner's Manual

7
Lift the display away from the computer at a 90-degree angle. Ensure that the antenna cables
and display cable are free from the routing channels and that the cables move freely when you
lift the display.
When you replace the display, ensure that the ribbon tape around the display cable is securely
tucked underneath the tabs. Insert the antenna wires through the hinge cover opening and then
through the hole in the system board. Ensure that the antenna wires are not twisted and that they
are securely attached to the Mini PCI card.

Optical Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 81.
2
Turn the computer over.
3
Remove the optical-drive security screw.
display cable pull-tab
display cable connector
screw (4)
antenna cables
Adding and Replacing Parts
97