Vivotek FE8174V User Manual page 10

VIVOTEK
Connecting RJ45 Ethernet Cable
RJ45 Cable Dimension (unit: mm)
Recommended cable gauge: 5 to 8mm
Assembly Steps
1. Drill a hole on the rubber seal plug and
insert an Ethernet cable through the
opening.
2. Strip part of the sheath from the Ether-
net cable.
3
o: white/orange stripe
o
O: orange solid
O
g: white/green stripe
g
B: blue solid
B
b: white/blue stripe
b
G: green solid
G
br: white/brown stripe br
BR: brown solid
BR
4
Connecting DC Power Cable
1. Add the supplied rubber washer to the cable
as shown in the picture.
2. Feed the cable from the bottom of the cam-
era and tighten the plastic base for water-
proofing.
NOTE:
Connect the supplied power & IO cables if your
switch does not support PoE.
10 - User's Manual
1
3. You will need an RJ45 crimping tool to
1
2
3
4
5
6
7
8
4. Feed the Ethernet cable from the bottom of the
camera and through the hole. Attach the rubber
seal plug for water proofing.
1
2
Rubber Seal Plug
2
attach the Ethernet wires to a connec-
tor. When done, connect the cable to
the camera's Ethernet RJ45 socket.