Hitachi 51SWX20B Operating Manual page 19

A/V NETWORK SETUP WIZARD
5. Follow the steps below to setup your A/V network (See page 20 for A/V Network Codes).
There are six steps in the setup procedure (VCR setup example below).
HITACHI AV NET Wizard (step 1 of 6)
HITACHI AV NET Wizard (step 3 of 6)
(Enter Code "9999" to uninstall)
HITACHI AV NET Wizard (step 4a of 6)
HITACHI AV NET Wizard (step 5 of 6)
each of the 3 function keys below.
Your VCR should respond to one of these
keys. Now press NEXT to continue.
POWER
HITACHI AV NET Wizard (step 6 of 6)
Press DONE to finish this wizard or
Please check connections shown
try a different manufacturers code
6. Enter "9999" to uninstall the equipment from your A/V Network.
7. See Remote Control A/V NET button usage on page 24.
NOTES: 1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre-
coded into the A/V Net.
2. In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please
consult your equipment receiver operating guide.
This Wizard helps you with
VCR connections and settings.
Would you like to setup or
modify your VCR?
BACK NEXT
Find your VCR
4-digit manufacturers code
and enter it here - - - -
BACK NEXT
Proper Code Entered
from page 20.
Which TV Rear Panel Input
is connected to your VCR?
(b) ANT A ( ) INPUT 3
( ) ANT B ( ) INPUT 4
( ) INPUT 1 ( ) INPUT 5
( ) INPUT 2
BACK NEXT
Turn ON your VCR then press
PLAY CH UP
BACK NEXT
Did your VCR respond to
POWER, PLAY or CH UP?
HELP to trouble shoot settings.
HELP DONE
HELP
TROUBLE SHOOTING
in the EASY GRAPHIC GUIDE.
If connections are correct,
for your VCR
0 4 3 6
BACK NEXT
HITACHI AV NET Wizard (step 2 of 6)
Follow the digrams shown in Hitachi's
Easy Graphic Guide
to connect your VCR.
Carefully position the IR "mouse" in front
of your VCR as shown in the diagrams.
BACK
ATTENTION
The 4-digit code did not match
AV Net's library. Please check
If Error
and re-enter a valid code
BACK
HITACHI AV NET Wizard (step 4b of 6)
Which RF channel does your VCR
use to send video to the TV?
(b) Channel 03
ANT A/B
( ) Channel 04
BACK
HITACHI AV NET Wizard
Congratulations!
Your VCR is now conected
DONE
to your AV network.
From Step 3, once you enter "9999",
the following message appears.
HITACHI AV NET Wizard (step 3b of 6)
This will uninstall VCR
on INPUT 1.
Would you like to proceed?
BACK
19
NEXT
- - - -
NEXT
NEXT
YES