Assembly - Shindaiwa T282 Owner's/Operator's Manual

Assembly

This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Handle and barrier bar X unit
The handle is attached at the factory and
positioned vertically.
1. Loosen socket headed capscrew at the
base of handle and rotate the handle 90
degrees.
NOTE:
Keep handle forward of handle position-
ing label!
2. Position the handle forward of the Handle
Positioning Label at the best position for
operator comfort (usually about 254 mm
(10 inches) ahead of throttle housing).
3. Tighten the socket headed capscrew
securely.
6
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
■
Engine and shaft assembly
■
Cutting attachment shield
■
Cutting attachment
Handle
Outer Tube
Barrier Bar
■
Kit containing cutting attachment
shield, mounting bracket and hardware,
this owner's/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
Hanger
Handle
Handle Positioning Label
Throttle
Assembly