Cisco Linksys AG310 User Manual page 34

Adsl2 plus gateway with voip
Table of Contents

Advertisement

ADSL2+ Gateway with VoIP
Next Registration In. Shown here is the number of seconds until the next registration.
Last Called VoIP Number. VoIP stands for Voice over Internet Protocol, which is used by Internet phone calls. Displayed here
is the last Internet phone number called from the landline.
Last Called PSTN Number. Displayed here is the last landline number dialed by the Gateway.
Last VoIP Caller. The VoIP caller is the one who calls the Gateway via VoIP to obtain traditional phone service. Displayed here
is the number of the last VoIP caller.
Last PSTN Caller. The PSTN caller is the one who calls the Gateway from the traditional phone service to obtain VoIP service.
Displayed here are the name and number of the last PSTN caller.
Last PSTN Disconnect Reason. Displayed here is why the Gateway terminated the LINE port connection.
PSTN Activity Timer. Displayed here is the number of milliseconds before the Gateway disconnects the current gateway
unless the landline has some audio activity.
Mapped SIP Port. Shown here is the port number of the NAT mapped SIP port.
Call Type. Displayed here is the direction of the call.
VoIP State. Displayed here is the status of Line 1, Call 1.
PSTN State. Displayed here is the status of the PSTN call.
VoIP Tone. Displayed here is the tone playing to the VoIP call leg.
PSTN Tone. Displayed here is the tone playing to the PSTN call leg.
VoIP Peer Name. Displayed here is the name of the party at the VoIP call leg.
PSTN Peer Name. Displayed here is the name of the party at the PSTN call leg.
VoIP Peer Number. Displayed here is the phone number of the party at the VoIP call leg.
PSTN Peer Number. Displayed here is the phone number of the party at the PSTN call leg.
The following are the same as the status information for Line 1, Call 1 in the Line 1 Status section.
VoIP Call Encoder. Displayed here is the codec used for encoding the VoIP call leg.
VoIP Call Decoder. Displayed here is the codec used for decoding the VoIP call leg.
VoIP Call FAX. Displayed here is the status of the fax pass-through mode.
VoIP Call Remote Hold. This indicates whether the far end has placed the call on hold.
Chapter 6: Configuring the ADSL2+ Gateway
28
The Setup - Voice Tab

Advertisement

Table of Contents
loading

Table of Contents