Using The Remote To Control Vcr Functions; Precoded Vcr Buttons - Hitachi 43GX10B Operating Manual

Projection color tv

Service manual (119 pages)

Operating manual (10 pages)

Table of Contents

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your

VCR. (refer to page 29)

1. Turn ON your VCR.

2. Aim the remote control at the front of your VCR.

3. Press the DVD/VCR button to switch to the VCR pre-coded mode.

4. Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your VCR as shown on page 29.

The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is

programmed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.

5. The remote will now control you VCR.

EXCLUSIVE TV Buttons

These buttons are for

operating the TV.

NOTES:

1. If your VCR cannot be operated after performing the above procedures, your VCR s code has not been precoded into the

remote.

2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR

operating guide.

3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.

After replacing the batteries repeat the entire programming procedure as stated above.

4. The INPUT button will act as your VCR 100 button if required.

NOTE:

Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.