Using The Remote To Control Dvd Functions - Hitachi 43FDX20B Operating Manual

Projection color tv

Service manual (67 pages)

Table of Contents

Operating the precoded function for your DVD player.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of

your DVD player. (refer to page 29 for pre-codes)

Turn ON your DVD player.

Aim the remote control at the front of your DVD player.

Press and release the DVD/VCR button to switch to DVD pre-coded mode.

Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on page

29.

Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two

digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not

turn off, try a different two digit preset code.

The remote will now control your DVD player.

NOTES:

If your DVD player cannot be operated after performing

the above procedures, your DVD player's code has not

been precoded into the remote.

In the unlikely event that your DVD player cannot be

operated after performing the above procedures, please

consult your DVD player operating guide.

The remote control will remember the codes you have

programmed until the batteries are removed from the

remote control. After replacing the batteries repeat the

entire programming procedure as stated above.

DVD/VCR Button

This button allows the remote to control your DVD player by

setting it to DVD mode.

PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

NOTE:

Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.