Rear Panel Jacks; Monitor Out - Hitachi 43FDX20B Operating Manual

Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a
sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly to a different source
such as a cable box, only when ANT B is displayed as a main picture.
Audio/Video Inputs 1, 2, 4 and 5
The VID1~VID5 buttons will select each video source each time it is pressed. Use the audio and video inputs to connect external
devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable into the
left audio jack.)
NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 1 and 2, but only one of these inputs may be used at a
time.

MONITOR OUT

These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video
output.
NOTE: S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type.
AUDIO TO HI-FI Output
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television's main volume.
S-VIDEO Inputs 1 and 2
Inputs 1 and 2 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.
ANT A
TO
CONVERTER
S-VIDEO
ANT B
VIDEO
(MONO)
AUDIO TO HI-FI
AUDIO
R L
INPUT 1
S-VIDEO
VIDEO Y/VIDEO Y/VIDEO
(MONO) (MONO) (MONO)
P P
B B
L
L
L
P P
R R
R R
R
AUDIO AUDIO
AUDIO
INPUT 2 INPUT 4 INPUT 5
10

REAR PANEL JACKS

S-VIDEO
VIDEO
L L
R R
AUDIO
MONITOR
OUT