Chapter 5: Setting Up The Wireless-B Ethernet Bridge; Overview; Setup Wizard - Cisco Linksys WET11 User Manual

Wireless-B Ethernet Bridge

Chapter 5: Setting Up the Wireless-B Ethernet Bridge

Overview

Now that you've connected the Wireless-B Ethernet Bridge to your wired network, you are ready to set it up. The
Setup Wizard will guide you through all the necessary steps.

Setup Wizard

1. Insert the Setup CD-ROM into your PC's CD-ROM drive. The Setup Utility should run automatically, and the
screen in Figure 5-1 should appear. If it does not, click the Start button and choose Run. In the field that
appears, enter D:\setup.exe (if "D" is the letter of your CD-ROM drive).
• Setup - Click the Setup button to proceed with the Setup Wizard.
• User Guide - Click the User Guide button to open the PDF file of this User Guide.
• LINKSYS Web - Click the LINKSYS Web button to access the Linksys website using an active Internet
connection.
• Exit - Click the Exit button to exit the Setup Wizard.
2. Click the Setup button to begin the setup process.
3. Make sure the Bridge is correctly connected to your wired network (see Figure 5-2). Then click the Next
button.
Chapter 5: Setting Up the Wireless-B Ethernet Bridge
Overview
Figure 5-1: Welcome
Figure 5-2: Check Connection
9