Table of Contents
Advertisement
Table 1. LEDs
LED
Power
• Solid amber. The router is starting up.
• Blinking amber. The firmware is upgrading, or the
• Solid green. The router is ready.
• Blinking green. The firmware is corrupted. See
• Off. Power is not supplied to the router.
Internet
• Solid green. The Internet connection is ready.
• Solid amber. The Ethernet cable connection to the
• Off. No Ethernet cable is connected to the modem.
Wireless • Solid blue. The wireless radio is operating in either 2.4
• Blinking. The router is in WPS mode.
• Off. The wireless radios are off for both 2.4 GHz and 5
USB
• Solid blue: The router has accepted the USB device. The
• Blinking blue. A USB HDD is plugged in and is trying to
• Off: No USB device is connected, someone clicked the
HDD
• Solid green: The internal HDD is working fine;
• Solid green plus red: The HDD is 85% full.
• Blinking green: Someone pressed the Backup button; the
• Blinking green and red: The HDD is 95% full.
• Solid red: The HDD is not formatted, the HDD connection
• Off: No internal HDD is connected.
Restore Factory Settings button was pressed.
www.netgear.com/support.
modem has been detected.
GHz or 5 GHz mode.
GHz.
USB device is ready to be used.
connect.
Safely Remove Hardware button, and it is now safe to
remove the attached USB device.
SD card data is being copied to the internal HDD.
is loose, or there is a failure alert.
Description
4
Advertisement
Table of Contents
