Central Pneumatic 47016 Owner's Manual & Safety Instructions page 13

Delayed or inadequate cleaning will permanently clog the Spray Gun.
5. Remove Nozzle and soak it in solvent
until it is clean. Use old toothbrush
and toothpicks to remove any paint.
CAUTION: Do not immerse Spray Gun.
Note: Do not use metal objects to clean the
Nozzle to prevent damage to the passages.
6. Inspect fluid needle and make sure
it is not bent. If it is bent, have it
replaced by a qualified technician.
Air Supply Maintenance
Every day, perform maintenance on the air supply according
to the component manufacturers' instructions.
Storage
Store in a dry, secure area out of reach of children.
General Troubleshooting Chart
Problem
Sputtering Spray 1. Low paint level.
2. Cup tipped.
3. Clogged Air Vent.
4. Loose fluid inlet connection.
5. Loose/damaged fluid tip/seat.
Will Not Spray 1. No pressure at Spray Gun.
2. Fluid Knob not open enough.
3. Fluid too thick.
Overspray 1. Improper application speed.
(Paint drifting
2. Improper distance from workpiece.
to unintended
3. Too much air pressure.
objects.)
Fluid Tip 1. Dirty tip.
Leakage
2. Broken fluid needle spring.
3. Worn or damaged tip.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
Item 47016 For technical questions, please call 1-800-444-3353.
67181
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
7. Use appropriate solvent
8. Lubricate Spray Gun after cleaning.
Solution Disposal
After cleaning, dispose of cleaning solution
according to the solution manufacturer's
directions and local hazardous waste standards.
Possible Causes
(see Solvent Selection, left)
to wipe down Spray Gun body.
A non-silicon oil or a light lubricant may be
used on threaded connections before storing.
Likely Solutions
1. Refill.
2. Hold upright.
3. Clean Air Vent hole.
4. Tighten fluid inlet connection.
5. Adjust or replace fluid tip.
1. Check air hoses.
2. Open Fluid Knob.
3. Thin fluid or increase air pressure.
(Do not exceed maximum.)
1. Move moderately and parallel.
2. Adjust distance.
3. Reduce air pressure.
1. Clean tip.
2. Replace fluid needle spring.
3. Replace tip and/or needle.
Page 13