Central Pneumatic 47016 Owner's Manual & Safety Instructions page 10

Delayed or inadequate cleaning will permanently clog the Spray Gun.
4. Fill the Cup to 3/4 full. Close Cup.
5. Start the air compressor and set
the regulator to needed pressure.
Do not exceed maximum air pressure.
6. Test the consistency by spraying
on a piece of scrap material.
If it still appears too thick, add a very
small amount of thinner (not included)
and mix thoroughly. Use the proper
thinner for the type of paint. Thin
CAUTIOUSLY. Proceed slowly,
adding minimal amounts at a time.
DO NOT exceed the manufacturer's
thinning recommendations.
Fan Direction
Lock Ring
Nozzle
Figure D: Fan Direction
7. To change the direction of the
fan from horizontal to vertical,
loosen the Lock Ring and turn the Nozzle 90°.
8. After the adjustment, tighten
the Lock Ring by hand.
Pattern Adjustment
WARNING! Do not exceed the Maximum Air
Pressure shown on the Specification chart.
9. Adjust the air supply pressure during
operation with the Trigger fully depressed and
the Air Knob fully open.
If reducing air pressure for specific areas,
use the Air Knob.
Page 10 For technical questions, please call 1-800-444-3353.
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
10. Use the Pattern Knob to
Fluid Adjustment
11. Turn the Fluid Knob clockwise
Horizontal Fan
12. After setting up a piece of scrap
Vertical
Fan
adjust the spray pattern.
Turn Pattern Knob counterclockwise
(all the way open) to flatten the spray pattern.
Turn it clockwise for a round spray pattern
- see Figure E: Pattern Adjustment.
Flat/
Open
Figure E: Pattern Adjustment
until it is fully closed.
material, squeeze the Trigger in short
bursts while turning the Fluid Knob
counterclockwise to set the amount of fluid
- see Figure F: Fluid Adjustment.
Too Coarse Correct
(Increase
air flow)
Figure F: Fluid Adjustment
If spray is too fine:
Reduce the air pressure or allow more paint
to come out by opening the Fluid Knob.
If spray is too thick (globs of paint):
Close the Fluid Knob slowly,
checking the pattern after each adjustment.
Round/
Closed
Too Fine
(Decrease
air flow)
Item 47016
67181