Quick Clean Mode; Pause/Resume - iRobot Braava 300 series Owner's Manual

Quick Clean Mode

• Cleans 30% faster by focusing cleaning on open areas.
• Activate by holding the Sweep or Mop button for 3 seconds.
• You will hear a single beep followed by the "start cleaning" song.
• Braava typically cleans the same total area as the standard detailed
cleaning mode, but will skip detailed cleaning around furniture and some
walls to save time.
Pause / Resume
Braava will automatically pause if you pick it up or press any button
while cleaning.
• The cleaning mode button will flash blue to indicate the cleaning cycle
is paused. While paused, Braava will save the map of the area it has
already cleaned.
• To resume cleaning, place Braava within 6 feet of the Cube where it
originally started, facing in the same general direction it started.
• Press the flashing cleaning mode button.
• Braava will start cleaning while it determines its position on the map.
Once it confirms its position, it will drive to an area not yet covered and
continue cleaning.
• Braava may re-clean an area already covered or explore new areas of
cleaning while determining its position on the map.
• If you resume Braava where you paused it, it may take longer for the
cleaner to determine its position depending on its distance from the Cube.
• To exit Pause and quit the cleaning cycle, power Braava off by holding the
power button for 2 seconds.
Note: Braava can only be paused after it has locked onto the NorthStar
Navigation Cube at the beginning of the cleaning cycle.
global.irobot.com
15