Operating Braava - iRobot Braava 300 Series Owner's Manual

Operating Braava

Put On a Cleaning Cloth
1. Set Braava on its end and remove the cleaning pad.
2. A ttach a dry or wet cloth to the Multi-Purpose cleaning pad.
Lay the removable pad on an open cleaning cloth. Attach
cloth by tucking it into the gripping strips on both sides.
See the following page for the Pro-Clean Reservoir Pad.
3. R e-attach the cleaning pad. Magnets will help it snap back
into place.
1 2
CAUTION: Make sure the cleaning cloth does not drape
into the middle channel between the gripping strips as
this could impede sensor functions and safe operation.
18 Braava 300 Series Owner's Manual
Using the Pro-Clean Reservoir Pad
(Sold separately for Braava 320)
The Pro-Clean Reservoir Pad dispenses liquid as Braava mops to keep
the cleaning cloth wet longer.
Fill the reservoir
1.
2. F ill reservoir with water and replace fill
3. Fill the reservoir over a sink as a small
3
4.
TIP: Fluid dispenses at different rates depending on floor type and solution
on your floor, do not leave Braava unattended when mopping and
remove from floor once Braava stops cleaning.
When mopping is finished:
• Empty any remaining fluid from the reservoir.
• L eave the fill cap open to allow reservoir to dry completely.
Do not store the pad on Braava if wet.
• See page 22 for care instructions.
O pen the fill cap by pulling and swiveling it
to the side.
cap, pressing it in securely so it does not
leak. Visit global.irobot.com for information
about other cleaning solutions.
amount of fluid can leak out when the fill
cap is closed.
Dampen the blue Pro-Clean microfibre
cloth and press onto the velcro strips.
Do not use a dry cloth.
used. The first time you mop, start with the cloth only slightly damp
and then increase the starting cloth wetness if needed.
NOTICE: To avoid the Pro-Clean Reservoir Pad leaving excess fluid
global.irobot.com 19