Audio (Input) Function Section - Panasonic AG-HPX371E Operating Instructions Manual

Audio (input) Function Section

1 MIC IN (microphone input) jack (XLR, 3-pin)
• Connect a microphone (optional accessory) to this
jack.
• A phantom-powered microphone may be connected.
To use a phantom-powered microphone, set the menu
option F.MIC POWER to ON in the AUDIO SETUP
screen.
For details, refer to [Preparing for Audio Input]
(PDF page 104).
2 AUDIO LEVEL CH1/CH2 (audio channel 1/2
recording level adjustment) controls
• With the AUDIO SELECT CH1/CH2 switch positioned
to MAN, these controls can be used to adjust the
recording levels for audio channels 1 and 2.
• Note that the controls are designed to be locked. For
adjustment, each control must be depressed while
turning.
3 AUDIO SELECT CH1/CH2 (audio channel 1/2
automatic/manual level adjustment selector) switch
Use this switch to select recording level control mode
for Audio Channels 1 and 2.
Recording level automatically controlled.
AUTO:
Recording level manually controlled.
MAN:
For details, refer to [Adjusting Recording Levels]
(PDF page 62).
4 AUDIO IN (audio input selector) switch
Use this switch to select signals recorded through
audio channels 1 – 4.
FRONT: Records signals from a microphone
connected to the MIC IN jack.
W.L.(WIRELESS):
Records signals from a wireless receiver.
REAR: Records signals from audio devices or
microphones connected to the AUDIO IN
CH1/CH2 connectors.
1
7
4
 NOTE
To record 2-channel wireless input, switch both CH1 and
CH2 to W.L. position and set the menu option WIRELESS
TYPE in the AUDIO SETUP screen to DUAL.
5 AUDIO IN CH1/CH2 (audio channel 1/2) connectors
(XLR, 3-pin)
Audio devices or microphones may be connected here.
For details, refer to [When Using Audio Devices]
(PDF page 105).
6 LINE/MIC/+48V (line input/mic input/mic input +48V)
selector switch
Use to select audio signals input to the AUDIO IN CH1/
CH2 connectors.
LINE: Line input for audio signals input from an
audio device
MIC: Audio signal input from microphone with
internal power supply (the camera does not
supply power to a phantom microphone).
Audio signal input from a microphone
+ 48V:
that requires an external power supply
(the camera supplies power to a phantom
microphone).
 NOTE
Power is supplied when the menu option
R.MICPOWER in the AUDIO SETUP screen is
set to ON.
7 FRONT AUDIO LEVEL (audio recording level
adjustment) control
• This control adjusts the recording level of audio
channels 1 and 2.
• With the AUDIO SELECT CH1/CH2 switch positioned
to MAN, this control can be used to adjust the
recording levels for audio channels 1 and 2.
• Use the menu options FRONT VR CH1 and FRONT
VR CH2 in the AUDIO SETUP screen to select the
input connector this control will be used for.
8 Wireless slot
A Unislot wireless receiver (optional accessory) may be
attached here.
2 8 6
3 5
E-14