Power-Off - Fujitsu PRIMEPOWER 1000 User Manual

CHAPTER 3 Main Unit Power-on/off
3.2.2

Power-off

This section describes how to turn off the main unit.
Data destruction
Before shutting down power, the following events must be ensured, otherwise data may be
destroyed.
l All applications have finished processing.
l No user is using the components.
If necessary, back up files before shutting down.
(1) Power-off manually
There are two ways, a) and b), to turn on the main unit.
a) Power-off using the operator panel
If the Mode switch is set to LOCK, the power-off operation by the power switch is disabled.
Setting the Mode switch to UNLOCK or MAINTENANCE is required.
1
Put the cursor on
main unit once, then press the switch again within 10 to 30 seconds.
By the first press, the message below is displayed on the SMC.
pwrctrld: Power switch is pressed. Press power switch again
within 30 seconds to start shutdown procedure.
This message states that the second press of the button switch within 30 seconds after the first
press is recognized starts shutdown process. This message does not denote the main unit failure.
This activates the shutdown process. Wait until the shutdown process finishes, it may take a few
minutes.
The message "Power OFF..." is displayed on the panel while the power of the main unit is
shutting down and after the shutdown process of the partitions is completed. After power off
completion, the message "Power ON Ready" appears.
The allowable number of times to cycle the power switch can be changed by the "scftool"
command of the Enhanced Support Facility.
2
After powering off the main unit, turn off the peripheral power switches.
For information on the power-off conditions restricted by the state of the Mode switch on the
operator panel, see
20
C and press the power switch on the operator panel of the
" "
Section 5.1.3, "Mode Switch."
C120-E093-04EN