Assembly - NordicTrack 29835.0 User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• To identify small parts, see page 5.
1. Remove and discard the shipping brackets (not
shown) on the front and rear of the Frame (1).
Identify the Front Right Stabilizer Tube (145),
which has a Wheel (34) in the indicated location.
While a second person lifts the front of the
Frame (1), insert some packaging materials (not
shown) under the Frame. Have the second per-
son hold the Frame to prevent it from tipping.
Attach the Front Right Stabilizer Tube (145) to
the Frame (1) with three M10 x 20mm Screws
(91) and three M10 Split Washers (105).
Attach the Left Front Stabilizer Tube (not
shown) in the same way.
Then, remove the packaging materials from
under the Frame (1).
2. Identify the two Rear Stabilizer Tubes (2).
While a second person lifts the rear of the Frame
(1), insert some packaging materials (not shown)
under the Frame. Have the second person
hold the Frame to prevent it from tipping.
Attach a Rear Stabilizer Tube (2) to the Frame
(1) with three M10 x 20mm Screws (91) and
three M10 Split Washers (105).
Attach the other Rear Stabilizer Tube (2) in
the same way.
Next, tighten the Small Leveling Foot (136) into
the Frame (1) in the indicated location.
Then, remove the packaging materials from
under the Frame (1).
• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one rubber mallet
Assembly may be easier if you have your own set
of wrenches. To avoid damaging parts, do not use
power tools.
1
2
2
1
105
91
6
1
145
34
105
105
91
136
2
105