Assembly - NordicTrack NEL5095.1 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrenches and your own phillips screwdriver
rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21.
The second number is the quantity used in assembly. Note: Some small parts may have been pre-assem-
bled. If a part is not in the parts bag, check to see if it is pre-assembled.
M10 Split
Washer (73)–2 Washer (85)–4
M8 x 44mm Button Screw (84)–8
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (64).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
.
M8 Split 7.6mm Spacer
(47)–2
M10 x 108mm Button Screw (70)–2
M4 x 16mm
Round Head
M8 x 56mm Button Screw (83)–4
Screw (69)–4
M8 x 79mm Bolt Set (65)–2
1
1
64
84
4
and
4, 5
8
84