Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench
Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each
drawing refers to the key number of the part, from the PART LIST on page 25. The second number refers to the
quantity needed for assembly. Note: Some small parts may have been pre-assembled for shipping. If a part
is not in the parts bag, check to see if it has been pre-assembled.
M8 Split
Washer (55)–12
M4 x 16mm
Screw (57)–5
M8 x 40mm Button
Bolt (81)–4
1. Identify the Front Stabilizer (15). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with four M8 x 40mm Button
Screws (54) and four M8 Split Washers (55).
M8 Washer
M10 Split
(60)–4
Washer (88)–2
1/4" x 16mm Button
Screw (80)–8
M10 x 118mm Button Screw (78)–2
M8 Nylon
Locknut (89)–4
M8 x 25mm Button
Screw (79)–4
M10 x 52mm Button Bolt (82)–2
1
15
5
.
M10 Nylon
Locknut (63)–2
M8 x 40mm Button
Screw (54)–8
1
55
55
54
54
Advertisement
Table of Contents
