AT&T MDW 9000 Quick Reference page 8

Troubleshooting
Symptom
After pressing
[ ], the handset
On/Off
beeps and RANGE
shows in the hand-
set display.
No ring on incoming Handset is out of range of
call, RANGE appears its matching radio module.
in handset display.
While talking and You are approaching an
walking, the handset
out of range condition.
beeps and RANGE
flashes in the hand-
set display.
While talking and You are out of range of
walking, the handset
the radio module. YOUR
beeps and RANGE CALL HAS NOT BEEN
flashes in the hand- DISCONNECTED. IT
HAS BEEN PLACED ON
set display. You keep
walking away from HOLD.
the handset's match-
ing radio module, the
display goes blank,
and your call appears
to be disconnected.
After placing a call
You are out of range of the
on Hold, you walk radio module. YOUR
further away from CALL HAS NOT BEEN
the handset's match- DISCONNECTED. IT
ing radio module. IS STILL ON HOLD.
Your handset beeps,
the handset display
flashes RANGE, and
your call appears to
be disconnected.
Possible Causes
Handset is out of range
of its matching radio
module.
An electrical device may
be interfering with your
communications link.
7
Possible Solutions
Move the handset closer
to the radio module.
Remove interfering device
or power it off, or move
handset to another
location.
Move the handset closer to
the radio module.
Move back towards the
handset's matching radio
module until the display
stops showing RANGE.
Move back towards the
radio module. Press [
On/Off
then proceed as you would
for any call placed on Hold.
Move back towards the
radio module. Press
[ ], then proceed as
On/Off
you would for any call
placed on Hold.
],