Assembly - NordicTrack NTL61011.2 User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• To identify small parts, see page 6.
1. Make sure that the power cord is unplugged.
Locate the Upright Wire (70) bundled around the
front of the Base (80) beneath the Belly Pan (68).
Cut the plastic tie securing the Upright Wire.
Route the Upright Wire into the Base and out of
the indicated hole.
Press a Base Cap (77) into each side of the
Base (80).
See the inset drawing. Cut the plastic tie near
the Upright Wire (70). Be careful not to damage
the Upright Wire.
• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1.
80
68
Cut
77
7
70
Tie
Hole
Cut
70