Installing The Alarm Termination Box (Atb); Installation; Figure 6 Alarm Terminal Block (Atb) Connections - Honeywell VideoBloX Quick Start Manual

Installing the Alarm Termination Box (ATB)

Installation

External
Power Supply
Relay Ratings
1A @ 30 VDC
0.5A @ 24 VAC
Rev 1.0
The ATB is shipped with the VideoBloX system and consists of a stainless steel box with a
ribbon cable.
• Support for 32 Alarm Inputs - potential free (dry) contact
• Support for 4 Form C Relays
• Removable Terminal Blocks
1. Connect the ATB to the VideoBloX CPU using the ribbon cable supplied.
2. Connect a toggle switch or other alarm device to activate the alarm signal to Input #1
of ATB.
3. Connect an output device (lamp or sounder) to the Common/Normally Open of
Output #1 and the appropriate power supply.
Figure 6 Alarm Terminal Block (ATB) Connections
Controlled
Device
RelayOutp ut s
Ribbon Connector
to CPU
ALARMTERMINATION BOX
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15
OUT2
17 18 19 20 21 22 23 24
OUT3
OUT4 25 26 27 28 29 30 31 32
AlarmInput s
11
VideoBloX Quick Start Guide
Typical Input
NO/NC Dry Contact
Alarm Inputs are
pulled to 5 VDC by
10K resistor.
Document 900.0840
09/06