Troubleshooting; Please Do Not Return This Product To The Store - Bissell PowerWash Deluxe User Manual

Troubleshooting

Reduced Spray OR No Spray.
Possible Causes
Bladder may be empty.
1
The Lint Screen may be clogged.
2
Tank-in Tank may not be seated properly.
3
Pump may have lost prime.
4
The Pump Belt may be broken.
5
DirtLifter PowerBrush* Does Not Turn.
Possible Causes
The Brush Belt or Pump Belt is off or broken.
1
*On select models only
Cleaner Not Picking Up Solution
Possible Causes
ReadyTools Dial may be at the
1
wrong setting for the cleaning job.
Nozzle Window may not be properly attached.
2
Tank-in-Tank lid is not installed.
3
Tank-in-Tank is not properly seated.
4
Poor tool position (Hand held attachments only).
5
Tank-in-Tank has picked up maximum dirty water.
6
ug310-5806_1694E_804.indd 17 ug310-5806_1694E_804.indd 17
Lift Here
Insert Screwdriver
Blade Here
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

WARNING:
To reduce the risk of fire,
electric shock, or injury,
unplug machine from
outlet before servicing.
Remedies
Refill Bladder with clean hand hot tap water.
1
Clean out Lint Screen, page 8.
2
Turn Power Switch OFF and reseat tanks.
3
Turn Power Switch OFF; after 1 minute turn ON
4
and depress Spray Release Trigger.
Turn Power Switch OFF and unplug machine
5
from the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into the lower
slot of the Belt Access Door to release the lower
snap. If necessary, insert the blade end into the
upper slot to release the upper snap. Examine
the belt for breakage. You should be able to see
the Pump Belt looped around the motor shaft. If
it is broken or missing, please refer to
Replacement Parts on page 19 before calling
BISSELL Consumer Services. Complete
installation instructions will accompany the
replacement Belt.
Remedies
Turn Power Switch OFF and unplug machine from the
1
outlet. To check if a Brush or Pump Belt has broken, you
will need a flat head screwdriver. Insert the blade
end into the lower slot of the Belt Access Door to
release the lower snap. If necessary, insert the blade
end into the upper slot to release the upper snap.
Examine the belt for breakage. If broken refer to
pages 15-16.
Remedies
Set ReadyTools Dial to either Tools/PreTreat
1
or Floor Cleaning.
Press down firmly on the black oval gasket at the top
2
Window to make sure the two tabs on the back of the
Nozzle Window are snapped into the mating slots in
the main housing.
Re-install lid; refer to the Features section.
3
Tank-In-Tank must be firmly seated to function; remove
4
and reseat Tank-in-Tank.
Adjust angle; apply more downward pressure.
5
Empty Tank-in-Tank, refer to the Features section.
6
17
3/29/06 3:43:03 PM 3/29/06 3:43:03 PM