Zone 2 Operation From The Lmc-1 Zone 2 Remote; Zone 2 Preamp Outputs With External Amplifi Cation; Using The +12 Vdc Control Output To Turn On Other Devices - Emotiva LMC-1 Manual

Zone 2 Operation from the LMC-1 Zone 2 Remote

For remote control operation in Zone 2, you MUST aim the I/R remote at the RRC-
1 wall plate so it can receive the commands. To turn Zone 2 ON from the Zone 2
remote control, press the "STANDBY" button on the right side. Repeat this step to
turn Zone 2 back OFF.
To select a source component, press any one of the available inputs (CD, DVD,
CABLE, VCR, TAPE, AUX1, AM, or FM). If you press the "SYNC" button the Zone 2
source becomes the same input source as the one selected for the Main Zone.
If you choose "AM" or "FM" for the Tuner input, you can scroll through the preset
channels on the present band by using the "RADIO CH+" and "RADIO CH -"
buttons. Manual tuning or direct frequency input can only be operated at the front
panel of the LMC-1.
To adjust volume, press "VOLUME +" or "VOLUME -" on the remote until you
achieve the desired volume. To mute the Zone, press "MUTE" on the remote.
Zone 2 Preamp Outputs with External Amplifi cation
If you choose to have a power output greater than that of the internal Zone 2 amplifier contained
within the LMC-1, you can use the analog RCA audio outputs at the back of the unit labeled ZONE.
See page 23 for connection information on this procedure.
Please note that whenever Zone 2 is set to "ON" in the OSD menus or it is being used from the
optional RRC-1 Keypad, the circuitry inside the LMC-1 will be "awake" even though the front
panel lighting and display of the LMC-1 are not. This will cause the Control Output (3.5mm jack)
for external amplifiers to stay (or remain) active in the event there is an external Zone 2 amplifier
as described in this section. This is normal operation and will not harm the Main Zone amplifiers
whatsoever because the audio outputs to the Main Zone amplifiers are switched off when only Zone 2
is operating.

Using the +12 VDC Control Output to Turn On Other Devices

The Control Output is current limited to 120mA, so it may not be adequate to turn on more than 1
multi-channel amplifier. If you prefer that additional amplifiers or additional gear (lighting control,
projector power, etc.) be controlled with the LMC-1 Control Output, please contact your Emotiva
dealer for custom installation options. In many cases, the device control you desire can be integrated
with a single command sequence through macro programming on a custom remote control setup.
Page 44