Elation Event Bar User Instructions page 6

Event Bar
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX State - This mode can be used as a precaution mode,
that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as the
operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until "DMX State" is displayed, press
ENTER.
2. Either "Master Slave", "Blackout", or "Last State" will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master Slave - If the DMX signal is lost or power is applied, the
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Back Light - With this function you can have the LED dis-
play turn off after 20 seconds.
1. Press the MENU button until "Back Light" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display On at all
©Elation Pr fessionals® - www.elationlighting.com - Event Bar Instruction Manual Page 11
o
System Menu & Operation Event Bar
times, or "OFF" so that the LED display turns off after 20 sec-
onds.
3. Press ENTER to confirm.
Manual Test - This function will let you manually test the
pan, tilt, & dimmer of each light.
1. Press the MENU button until "Manual Test" is displayed,
press ENTER.
2. Use the UP and DOWN buttons to test the four lights. To exit
manual test press either the MENU or ENTER button.
Auto Test - This function will run a self test program.
1. Press the MENU button until "Auto Test" is displayed, press
ENTER.
2. The fixture will now run a self test program. To stop the self
test press the MENU button.
Pan Inverse
1. Press the MENU button until "Pan Inverse" is displayed,
press ENTER. Either "Inverse" or "Normal" will be displayed.
2. To activate the Pan inversion tap the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Pan inversion, select "Normal" and press Enter.
Tilt Inverse
1. Press the MENU button until "Tilt Inverse" is displayed, press
ENTER. Either "Inverse" or "Normal" will be displayed.
2. To activate the Pan inversion tap the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Pan inversion, select "Normal" and press Enter.
Fixture Time - With this function you can display the run-
©Elation Pr fessionals® - www.elationlighting.com - Event Bar Instruction Manual Page 12
o
System Menu & Operation